Hydraulic Mill Roll Stand
Technical Parameters:
1 Original paper shaft motion type : full hydraulic type motion .
2 Paper carry width : max 1600mm , min 900mm
3 Paper carry diameter : max Φ1500mm
4 Max loading weight for single side : max 2000 Kg
5 Main roller diameter of paper shaft : Φ245mm
6 Air source working pressure : 0.4 - 0.8 Mpa
7 Working power supply : can be customized
Structural Features:
1Adopt hydraulic drive to complete the paper clamping, loosen, remove for the medium, translation left and right and others，the lifting of the paper adopts hydraulic drive.
2The Structure is Double Rotary Shafts with Four Arms
3brake adjustable adopt single braking system.
4Support Two Paper Mill Rolls on both Arms at the Same Time
5Web Tension Controlled by Pneumatic Brake or Manual Brake
Fingerless Type Single Facer
Machine information :
Design Speed:60-80m/min
Effective width:1600mm
Corrugated roller:φ280mm
Steam heating type.
Flute type : according to customer choose.
1. Drive reducer box with oil immersed type lubricating to reduce noise keep running stable. adopt gimbal transmission. separate power.
2. Corrugatingroller, pressure roller and glue roller by pneumatic adjustment.
3. Cardboard transmit adopt vacuum suction method, with wind control system. keep flute profiles stable of the lower-roller in the condition of running up.
4. Bearing of corrugated and pressure roller adopt high temperature lubricate grease. Glue parts auto supply glue circularly.
5. The upper-lower corrugating roller are made of 48CrMo high quality alloy steel, after heat-treatment. The hardness HRC58°-60°,the surface be grinded.
6. The glue part surface are treated by special mesh snicked and chromeplated.
7. Motorized or manual glue width dividing to match the paper width.
8. Glue part can be running independently or non-independently while stopped. Adopt main motor frequency conversion control.
Rotary cutter machine
Machine information :
Series circle the tube paper roll knife to slice paper machine, main use come circle the tube paper cut into Flat sheets of paper of specification needed, have structure simple, adjust convenience, the service life be long etc. Advantage.
1)the sheet cutter with stacker unit,using inlet synchronous driving device,can running and sharpening simultaneous,improve production efficiency.
2) rational mechanical structure, strong form, good stability , have long performance life.
3) all operation control on the same side, easy to operate.
4) Max feeding paper : 1600mm
5) cut paper precision±2.5mm.
6) working speed : 60-80m/min
Previous: No more
Next: No more
